FattyMatt 0 Report post Posted July 15, 2015 Does anyone know the specs on the O-Ring for this vise? I finally broke it after a couple years and I went to their website but I can't seem to fine what size this is. Id like to buy from local hardware store if possible. Thanks, Matt Quote Share this post Link to post Share on other sites
Steven Wiersma 0 Report post Posted July 15, 2015 If you have the broken ring, take it to the hardware. They will match the ring. Alternatively, take the vise to the hardware. Quote Share this post Link to post Share on other sites
FattyMatt 0 Report post Posted July 15, 2015 Here's the ring. Just wondering if anyone else has been able to find a replacement in local stores and if so what size. Quote Share this post Link to post Share on other sites
RogueFlies 0 Report post Posted July 16, 2015 Griffin has a lifetime warranty, email them theyll probably send you a new one Quote Share this post Link to post Share on other sites
Gene L 0 Report post Posted July 16, 2015 If you have a decent hardware store, they'll sell you one for a few cents. My local hardware store sells these things by the piece. If you want to be on the safe side, get a size bigger than you think and a size smaller. Probably a quarter at most. Quote Share this post Link to post Share on other sites
flytire 0 Report post Posted July 16, 2015 Here's the ring. Just wondering if anyone else has been able to find a replacement in local stores and if so what size. measure the inside and outside diameter and youll know what size it is like others have said take it to the big box hardware store and look in the specialty fasteners aisle for a new one if you need a chart http://www.allorings.com/size_cross_reference_framed.htm Quote Share this post Link to post Share on other sites
epzamora 0 Report post Posted July 17, 2015 Contact Griffin. I mean, call them. They will probably send you the replacement for free. eric fresno, ca. Quote Share this post Link to post Share on other sites
SILKHDH 0 Report post Posted July 17, 2015 No probably about it. Call them, you WILL get a new on free. They are awesome about things like this. Quote Share this post Link to post Share on other sites
Gene L 0 Report post Posted July 17, 2015 No probably about it. Call them, you WILL get a new on free. They are awesome about things like this. In about a week by post office. Meanwhile, you can go to your local hardware store and lay down a few cents and have one in ten minutes. Quote Share this post Link to post Share on other sites
jakonyx 0 Report post Posted July 17, 2015 Just guessing from the photo but it looks to be a 3/32 cross section so it is probably a -109 or a -110. Just measure it with a ruler if no one here can give you the size. It will only require a ruler measuring in -32's. Pay more attention to the ID as if I remember the vise from pictures the OD won't matter. Just my 2 cents worth which is probably what the o-ring will cost. Quote Share this post Link to post Share on other sites
Kentuckysteve 0 Report post Posted July 18, 2015 Any auto parts store will also have them. Quote Share this post Link to post Share on other sites