Val Schmaus 0 Report post Posted September 13, 2021 Recently I came across a 1932 Granger Rod.The tip section has is about a 4" bow in it when laid on a flat surface.I think its from being in the trunk of a car for the last 6 months.Is it possible to straighten it back to original or am I wasting my time? Quote Share this post Link to post Share on other sites
skeet3t 0 Report post Posted September 13, 2021 Make a jig with a board and nails to bend the rod. Nails at the proper places will help straighten it. Basically you are bending it at the opposite the curve. Put it in the jig and watch it. Did this with my old 'boo rod. Do not heat it in any way! Quote Share this post Link to post Share on other sites
chugbug27 0 Report post Posted September 13, 2021 Go to classicflyrodforum.com for this one -- plenty of makers and restorers active there. Quote Share this post Link to post Share on other sites
skeet3t 0 Report post Posted September 13, 2021 chugbug mentions a good site but it's a DIY as I have noted. They will do the same thing. Quote Share this post Link to post Share on other sites
Val Schmaus 0 Report post Posted September 14, 2021 Thanks All,I'll give it a try. Quote Share this post Link to post Share on other sites
Sandan 0 Report post Posted September 14, 2021 Yep, just like chug said check out the classicflyrodforum.com Quote Share this post Link to post Share on other sites
Steeldrifter 0 Report post Posted September 14, 2021 A simple hair dryer set on low is the normal way to do it most times. Have done it myself back when I offered cane rods for awhile many years ago when Bob use to make the cane blanks for me. Most important thing is to not get it too hot, just set to low and let it warm up slowly. Quote Share this post Link to post Share on other sites
tjm 0 Report post Posted September 16, 2021 I used low heat to take set out of my Montague. But, there are supposedly some early glues that heat affects. Rule I've read is don't get it too hot to hold with your bare hand. Search the web for "straighten set bamboo fly rod" , you'll find some experts. Quote Share this post Link to post Share on other sites