SBPatt 0 Report post Posted September 30, 2019 Found this on the Uni products site. Original had a Madam X half-head; I prefer standard bullet. Tied here as an October Caddis; change color/size to suit your needs. hook Dai Riki 300 #8 thread/rib - UTC 140 burnt orange body - 1mm foam shellback - 2mm foam rust head/wing - deer hair legs - medium rubber brown indicator - 1mm foam orange Mash barb, start thread at head Clean, stack, measure (hook length + gap) a clump of deer hair; trim butts, tie in with 2 soft loops, spin, trim butts Tie in 2mm foam strip (3/4 gap width), wrap to bend Tie in 1mm foam strip; wrap to head, tie off/trim Brush top of body with Super Glue, pull shellback forward; tie down/trim Push deer hair back, evenly distributing around shank Pull deer hair back, tie down with 2 soft loops, pull tight Add legs Indicator Whip finish, SHHAN Flip over, trim out hair underneath Trim legs/indicator Regards, Scott Quote Share this post Link to post Share on other sites
DarrellP 0 Report post Posted October 13, 2019 Excellent sbs sir Quote Share this post Link to post Share on other sites