SBPatt 0 Report post Posted August 18, 2017 Similar to the RDH Stone with a Henry's Fork Hopper body and optional legs. Tied as an October Caddis; if the fires haven't shut down all the rivers up here over the next few weeks, may give it a try, in addition to foam stuff. hook - Dai Riki 280 #10 thread/rib - UTC 140 burnt orange abdomen/wing/hackle - deer hair dyed orange legs - medium rubber orange mash barb, start thread at 2/3 mark; wrap to bend and back clean, stack, trim tips on a clump of deer hair; tie in by tip with a couple loose wraps, allowing the hair to encircle the shank wrap to point above barb pull butts forward, encircling shank, spiral rib back to tie in; tie off/trim butts clean, stack, measure (tips gap width past bend) a clump of deer hair; tie in/trim butts tie in legs create thread loop, wax clean, stack a clump of deer hair, insert in clip, trim butts; insert clip in loop, adjust tips (should be about 1 1/2 x gap width), spin stroke fibers back, wrap hackle, tie off, whip finish, SHHAN trim legs, trim out hackle underneath Regards, Scott Quote Share this post Link to post Share on other sites