LeftyPa 0 Report post Posted April 24, 2005 I found some small black beads in a craft shop. I took some braided mono fly backing line and melted the end into a narrow strand so that I could thread on the beads.After threading on some beads, I dabbed a spot of 5 minute epoxy below each bead and slid the bead over the epoxy. By spacing the beads carefully, you can end up with matched pairs of eyes for shrimp or pairs of eyes with stalks for crabs. John Share this post Link to post Share on other sites
Caddisman1 0 Report post Posted June 23, 2005 I tried you idea it works really good ,you can make many differant kinds of eyes. Thanks John Share this post Link to post Share on other sites
broadcj 0 Report post Posted February 16, 2006 For bead-heads, go to your local mom and pop hardware store and buy some cieling fan chain. It's usually cheaper than from a fly shop and sometimes you can find a few size options, especially if they carry the pull chains for table and desk lamps. Good Luck, Jake Share this post Link to post Share on other sites
down2earthlv 0 Report post Posted February 16, 2006 Remember your army surplus stores! Soldiers have been hanging their dog tags from bead chain eyes for a very long time now...... I doubt any of them ever had much of an idea...... Share this post Link to post Share on other sites
flyrod98 0 Report post Posted March 3, 2006 While you are at the hardware store for the ceiling fan chain, check out the bathtub plug chain for some bigger eyes. Share this post Link to post Share on other sites