DFoster 0 Report post Posted April 30, 2021 1 hour ago, flytire said: before you go caveman and start hammering or greasing it up, send dyna king and email with the picture and an explanation of the problem and let them help you out for a better solution [email protected] Agreed, that's a nice piece of equipment so contacting the people that built should be the first step before grabbing the cutting torch 😉 Quote Share this post Link to post Share on other sites
Mark Knapp 0 Report post Posted April 30, 2021 8 hours ago, flytire said: before you go caveman and start hammering or greasing it up, send dyna king and email with the picture and an explanation of the problem and let them help you out for a better solution [email protected] Who you calling a cave man? 😁 Good idea though. An email can't hurt. Quote Share this post Link to post Share on other sites
Mark Knapp 0 Report post Posted April 30, 2021 I literally took mine apart, put back together again, uploaded the picture and wrote this since my last post. It took 5 seconds to get it apart and five seconds to put it back together again. This is what it looks like. Hit it with a soft blow, It should take just a bump. Mine was actually a slide fit. Make sure all three screws are lose on the barrel. Quote Share this post Link to post Share on other sites
Poopdeck 0 Report post Posted April 30, 2021 YOU DID WHAAAAAAAAT!!! Only a caveman would think they could take something apart and put it back together again without an email. Neanderthal. Nice job Mark! Quote Share this post Link to post Share on other sites
flytire 0 Report post Posted May 1, 2021 well sometimes going caveman works Quote Share this post Link to post Share on other sites
FliesbyNight 0 Report post Posted May 1, 2021 Greg, Had my Barracuda for about 5 years now and never had that problem. If you get a solution from DynaKing, please post it here. I also favor the Fred and Barney approach although it sometimes works out less than optimum. Hearing how you fixed yours might help avoid a bigger problem. Quote Share this post Link to post Share on other sites
WWKimba 0 Report post Posted May 1, 2021 A roll of duct tape, a hammer and a can of WW40 walk into a bar... Quote Share this post Link to post Share on other sites
SilverCreek 0 Report post Posted May 1, 2021 On 4/29/2021 at 10:48 PM, Moshup said: “Oops”. The one word no one wants to hear in the operating room !😳 "Oops!" is never said in an OR. We say "There!" as if we intended it. Quote Share this post Link to post Share on other sites
Moshup 0 Report post Posted May 3, 2021 On 5/1/2021 at 10:33 AM, SilverCreek said: "Oops!" is never said in an OR. We say "There!" as if we intended it. Lol. I know a little about the OR Silvercreek.. Quote Share this post Link to post Share on other sites